Optical Module Application: Common Problems & Troubleshooting
Based on typical issues encountered with optical modules in daily switch applications, this document summarizes basic troubleshooting steps for resolving common faults:
Related Topics:
Optical Port Huijue Switch
How To Read Optical Module Information On Huawei Switches
The following uses the Moduletek SFP-10G-LR module connected to a Huawei S6700 switch as an example to introduce how to read information of the connected optical module on a Huawei switch.
Typical Troubleshooting Cases of Optical Module
Check whether the optical module is a Huawei-certified one. If not, replace it with a Huawei-certified optical module. If the optical module is installed on a GE port, run the display interface
Optical Module Solutions for Huawei S5700/S5720 Series Switches
Problem: All optical ports cannot be connected, and the indicator lights are not on. Solution: To solve this problem, you can follow these steps: Check if the fiber and optical modules
How To Check If Interconnected Optical Ports Cannot
If the problem is not caused by the optical modules, fibers, or intermediate device, connect the switch to another interface or replace the switch to check whether the
Troubleshooting for Optical Modules on Huawei Switch
Check whether the optical module is Huawei-certified. If it is not certified by Huawei, replace it with a Huawei certified one. Remove and reinstall the optical module. If
HUAWEI S Series Switch-Handle an Optical Interface''s Failure
HUAWEI S Series Switch-Handle an Optical Interface''s Failure to Go Up video provides guidance on how to handle an optical interface''s failure to go Up. HUAWEI S Series Switch...
Optical Module Troubleshooting
If a LOS alarm is displayed, the local optical interface does not receive any optical signal from the remote interface. Run the display this in the interface view to check whether the local and remote
Huawei Switches Viewing Optical Port Receiving and Sending
Use the command display transceiver to view the optical module information of all optical ports, and use the command display transceiver interface interface-type interface-number to view the
Checking the Interface Status and Configuration Parameters
If a message is displayed, indicating that the optical module is not in position, remove and then properly insert the optical module. If the auto-negotiation mode is used but the interface cannot go Up, set the